Diy Tap And Die Threading Paste
Made Using Bees Wax And Paraffin
melt in jar over hot water like if you were melting chocolate, care should be taken as its highly flammable best done outside on a camp burner.
35-40% bees wax to 60-65% paraffin but does depend on wax if to hard just add more paraffin
works well on mild steel and stainless steel.
Also works well on your hacksaw blades when cutting, Also use neat bees wax
Made Using Bees Wax And Paraffin
melt in jar over hot water like if you were melting chocolate, care should be taken as its highly flammable best done outside on a camp burner.
35-40% bees wax to 60-65% paraffin but does depend on wax if to hard just add more paraffin
works well on mild steel and stainless steel.
Also works well on your hacksaw blades when cutting, Also use neat bees wax
|
|
Description
A die is used to cut or form the male portion of the mating pair (e.g., a Bolt). The process of cutting or forming threads using a tap is called tapping, whereas the process using a die is called threading. Both tools can be used to clean up a thread, which is called chasing.
A die is used to cut or form the male portion of the mating pair (e.g., a Bolt). The process of cutting or forming threads using a tap is called tapping, whereas the process using a die is called threading. Both tools can be used to clean up a thread, which is called chasing.
Tap Drill Sizes Metric
Drill tap and countersink in one
Also take a look at the following sites http://www.wikihow.com/Use-a-Tap and
https://en.wikipedia.org/wiki/Tap_and_die
https://en.wikipedia.org/wiki/Tap_and_die